Filter
Top Products
33
1
Turn off the projector and unplug the power cord.
2 Wait 60 minutes to allow the projector to cool thoroughly.
3 Remove the lamp door, located on top of the projector, by removing the two
screws on either side of the lamp door, and lifting the lamp door off using the
latch at the front ofthe projector.
4 Loosen the captive screw that attaches the lamp housing to the projector.
NOTE:
If the projector is installed on a ceiling mount, be careful not to drop
the lamp module once the captive screw is loosened.
5 Carefully lift the lamp straight up, off of the alignment pins; being careful not to
pinch the lamp connector. Dispose of the lamp in an environmentally proper
manner.
6 Install the new lamp module, aligning the pins properly. Be careful not to pinch
the lamp connector.
7 Tighten the screw. (NOTE: If the pins have not been aligned properly, the
screw will not tighten securely.)
8 Replace the lamp door by (a) aligning the hinges, (b) putting the lamp door
down and (c) locking it back into place.
9 Replace the lamp door screws and tighten securely.
10 Plug in the power cord and press the Power button to turn the projector back
on.
11 To reset the lamp hour timer, navigate to the Advanced Menu > Status/Service
menu and select Reset Lamp Hours.... See page 31 for details.
turn off and unplug
projector
wait 60 minutes
loosen screw
Image
Serial
Setup
Status/Service
Basic Menu
Source Info...
Projector Info...
Reset Lamp Hours...
Factory Reset...
Service Code...
( Advanced Menu )
SN: BHQM91001936
MDL: IN146
FW: 0.19