Filter
Top Products
16 Intel Server RAID Controller U2-1 (SRCU21) Quick Start Guide
5 It will ask you confirm the boot partition creation. Select Continue. You
will then press a key to reboot.
6 When NetWare boots again, it will first format the newly created boot
partition, and then start loading files. During this initialization, you will
see a white graphical NetWare logo screen.
7 It will eventually load a Welcome screen, asking you to verify the startup
directory (C:\NWSERVER). Hit Alt F10 to exit the installation. At the
console, type “Down”. The installation exits to the boot drive prompt.
8 Insert the NetWare installation diskette into the A: drive. If your boot
drive is C:, then run NWUPDATE.BAT. If your boot drive is other than
C:, then create an NWUPDATE subdirectory and copy all the files from
A:\DRIVERS into the NWUPDATE subdirectory.
9 Remove the diskette from the A: drive and reboot the server. After booting
you will be asked to Accept the License Agreement. Do so and then select
“Continue with Existing Partition”. You are now ready to install
NetWare 5 on the Intel Integrated RAID volume.
10 Continue with the NetWare installation as normal by following the screen
prompts. Select the “Block Storage OSM” when prompted.
11 Reboot the server and install Service Pack 2a or higher. Once the server
installation is completed, reboot the server.
12 Install the Intel Integrated RAID software (run the Intel Integrated RAID
setup).
13 Run "NWCONFIG".
14 Select "Product Options", then "Install product not listed". It will tell you
that it is going to scan the A: drive for installation scripts. Ensure the
"NetWare Installation" diskette is in the floppy drive, hit Enter to
continue.
15 A screen prompt will ask which components you wish to install. Select all
of the components and hit F10 to continue.
BKSTROSM.HAM
SCSIOSM.HAM
HTTP and Winsock Services
RAID Management Agents
The appropriate files are copied and the AUTOEXEC.NCF and
STARTUP.NCF files are modified as necessary.
16 After the installation is complete, reboot the server to load the new drivers.
17 See Section 4.5 in the Intel Server RAID Controller U2-1 User's Manual to
customize your RAID volumes using Storage Console.