Filter
Top Products
35
Enable: Click to enable
or disable the firewall
rule profile.
Name: Type a descriptive
name for the firewall rule
profile.
Action: Select whether
to allow or deny packets
that conform to the rule.
Source: Defines the
source of the incoming
packet that the rule is applied to.
• Interface: Select which interface (WAN or LAN) the rule is applied to.
• IP Range Start: Type the start IP address that the rule is applied to.
• IP Range End: Type the end IP address that the rule is applied to.
Destination: Defines the destination of the incoming packet that the rule is
applied to.
• Interface: Select which interface (WAN or LAN) the rule is applied to.
• IP Range Start: Type the start IP address that the rule is applied to.
• IP Range End: Type the end IP address that the rule is applied to.
• Protocol: Select the protocol (TCP, UDP or ICMP) of the destination.
• Port Range: Select the port range.
Add: Click to add the rule profile to the table at the bottom of the screen.
Update: Click to update information for the rule if user have selected a list item
and have made changes.
Delete: Select a list item and click “Delete” to remove the item from the list.
New: Click to erase all fields and enter new information.
Priority Up: Select a rule from the list and click “Priority Up” to increase the
priority of the rule.
Priority Down: Select a rule from the list and click “Priority Down” to decrease
the priority of the rule.
Update Priority: After increasing or decreasing the priority of a rule, click
“Update Priority” to save the changes.
Management
Management enables the user to set up the Simple Network Management
Protocol (SNMP) and Remote Management features.
SNMP
This screen enables you to configure the SNMP.
CONFIGURATION