Filter
Top Products
14
Note: If you have previously paired to the Bluetooth serial adapter(s), make sure to follow
the unpairing procedure on page 29 before attempting to connect to a new device.
18
Set one serial adapter to Master (switch 4 = ON), and the other to Slave (switch 4 = OFF)
Method 1 –
Auto-paring
Follow steps below
Set matching baud rates as needed
Power On both serial adapters and wait approximately fifteen (15) seconds
·Blue LED on slave adapter will slowly blink (once every 2-3 seconds)
·Blue LED on master adapter will rapidly blink
Wait approximately two (2) minutes for the serial adapters to automatically pair and connect
1
Set device mode
2
Set baud rate
3
Power ON
4
Pair and Connect
Basic Configuration