Filter
Top Products
12
13
Make sure that all devices are properly
grounded.
Setting up the GCS661U is quick and easy,
offering simple plug and play functionality in just a
few short steps. Follow the steps below and refer
to the installation diagram on the following page:
1. Make sure that the Remote computer has the
monitor, keyboard and mouse connected. This
is required for a successful initial software
installation on that computer.
Hardware Setup
2. Turn on the Remote (desktop) computer.
Note: You may be prompted to type in a password
depending on how the computer was originally set
up. If so, type in the password and proceed with
the steps below. Remember that you will always be
asked for the password every time you turn on the
desktop. If you wish to remove it, see the
Troubleshooting section for additional details on
how to. It is recommended that you do remove the
password request especially if you plan to
discontinue the use of the monitor, keyboard and
mouse.
3. Plug the longer USB cable into a USB port on
the Remote computer.