Filter
Top Products
Hardware Installation
2. Replace existing keyboard and
mouse with the new IOGEAR Wireless
Keyboard/Mouse combo
Checklist – please check the following before
proceeding:
• Make sure your system has an available USB
port and the OS supports USB Hot-plugging
• You have connected the USB receiver to your
computer (your computer should detect it and
install all necessary drivers automatically)
CONNECT THE MOUSE
1. Look for the ON/OFF switch on the bottom of
the mouse and make sure that it is set to the
ON position
2. Press the Connect button on the USB
receiver; the connect LED will light up green.
3. Press and hold the connect button, located
on the bottom of the mouse, for a few
seconds
4. Move the mouse around and make sure that
it is functioning properly. If the mouse does
not work, please repeat the procedure again.
CONNECT THE KEYBOARD
1. Press the Connect button on the USB
receiver; the connect LED will light up green
2. Press and hold the connect button, located
on the bottom of the keyboard, for a few
seconds
3. Tap the keys on the keyboard or type
something to verify that it is working properly.
If it doesn’t work, please repeat the
procedure again
15
Note: If your system has any problems detecting the wireless keyboard
and mouse, please turn off your computer before following the steps
above. With your computer turned off, connect the USB receiver to an
available USB port, and then power on your computer. Upon boot-up,
the system should detect the wireless keyboard/mouse combo, and
install all necessary drivers automatically.