IOGear GKM541R Mouse User Manual


 
3. Install the wireless combo on a brand
new computer system
- Before you turn on the system, make sure the
batteries are installed for both keyboard and
mouse and mouse batteries have been charged
for at least two hours;
- Plug the USB charging station/receiver into an
available USB port on your computer
- Power ON your computer
- Upon boot-up, your Operating System should
detect the IOGEAR wireless keyboard/mouse
combo and install any drivers, if necessary.
- Press the connect button on the USB Receiver
Hardware Installation
- Press the connect button located on the bottom
of the mouse for a few seconds
- Move the mouse and make sure it is working
properly
- Press the connect button on the USB Receiver
- Press the connect button located on the bottom
of the keyboard for a few seconds
- Your IOGEAR Wireless Keyboard/Mouse Combo
should now work wirelessly. If not, repeat the
steps above again.
16