Filter
Top Products
Coaxial Networks, Inc. Page 37 of 60
psid............................ print MacAddress to Sid map
preg............................ print CM registration status
pcpe............................ print CM and associated CPE
config_cm <ifile> <ofile> ...... generate CM config file
(q)uit ......................... quit command interpreter
system ......................... go to the system prompt
reboot ......................... restart the system
shutdown ....................... shutdown the system
!............................... repeat last command
tty............................. displays the terminal name
passwd.......................... changes password for iris
upcon <cmd> .................... upconveter config command, upcon ? for list
setupl ......................... setup uplink (en2) IP network parameters
setif <if> <ip> <netmask> ...... sets interface ip address and netmask
showif [if] .................... show interface parameters, en1, en2
dhcp <cmd> ..................... dhcp server command, dhcp ? for list
bridge [on/off] ................ Enable or disable briding mode for IRIS
addcm <mac_address> [comment] .. Add CM to subscribed list
delcm <mac_address> ............ Delete CM from subscribed list
savecm ......................... Save subscribed CM list
psub ........................... Print subscribed CM list
punsub ......................... Print unsubscribed CM list
Figure 21 List of CLI commands
“preg” or ”preg verbose” command
The “preg” command displays you a list of MAC addresses of cable modems that have
communicated to IRIS, their SID (service identifier) and the current registered state.
IRIS>preg
Registered CMs
-------------------------------------------------------------------------------
MAC PSID USID STATUS
-------------------------------------------------------------------------------
00:0b:06:9f:a7:fe 0x0002 0x01 Yes
00:10:95:1b:e1:c5 0x0001 0x01 Yes
00:30:eb:bc:0c:a5 0x0004 0x01 Yes
00:90:83:8c:58:23 0x0003 0x01 Yes
00:e0:ca:00:c1:9c 0x0005 0x01 Yes
Total(5), Yes(5) No(0)
Unsubscribed CMs
-------------------------------------------------------------------------------
Total(0)
Figure 22 List of registered cable modems
“psid” command
The “psid” command displays you a list of MAC addresses of cable modems or PCs connected to
the cable modems. Each cable modem and PCs connected to them will have unique MAC address
but same SID or service identifier.
IRIS>psid
MAC address to SID map:
-------------------------------------------------------------------------------
MAC SID