Filter
Top Products
Coaxial Networks, Inc. Page 39 of 60
The “count” command displays the number of Interrupts, Packets received, Packets Transmitted
and Errors on the cable interface of IRIS.
“rcount” command
Resets the values of the above mentioned counters.
“ver” command
Displays the version of IRIS and IRIS CLI.
“reboot” command
Restarts the system.
“shutdown” command
Shuts down the system, so that it can be powered off safely.
“system” command
Takes you to the QNX system prompt from the IRIS CLI. To return back to the IRIS CLI, type
“exit” at the system prompt.
“quit” command
The quit command exits the IRIS CLI. On a telnet connection it would close your telnet session.
On the serial console, it will log out and display the login prompt gain.
“!” command
Repeats the last command that you had typed.
“tty” command
Displays the name of the terminal you are currently connected on.
“passwd” command
Prompts to change the “iris” password. You should change the “iris” password once you have
received the system. Make a note of the password in a safe place so that you do not forget the
password.