Filter
Top Products
Page 11
Installation
TM-1400 Series Progressive Scan Shutter Cameras
2.2.6 Camera Link Cable (CL Versions Only)
The MDR26 cable assembly (26CL-02-26) from 3M (part number 10226-6212VC) has been
standardized as the Camera Link cable. This cable has the 26-pin MDR26 connector on both ends. This
is a straight-through cable. The pin-out configuration is shown in Table 4 on page 8.
Note: For TM-1400CL, serial communication for camera control is done via the Camera Link
connector on the rear panel of the camera.
Cable assemblies and boardmount receptacles can be ordered from 3M.
2.2.7 Power Supplies and Power Cable Setup
2.2.7 (a) Power Supplies
The TM-1400 requires 12V DC power that is obtained through the 12-pin connector located on the rear
panel of the camera. JAI PULNiX recommends the following power supplies:
PD-12UU 100-240V AC/12V DC 1.2A universal voltage power supply with
US plug
PD-12UUP 100-240V AC 1.2A universal voltage power supply with US plug
and 12-pin connector
PD-12UE 100-240V AC/12V DC 1.2A universal power supply with European plug
PD-12UEP 100-240V AC/12V DC 1.2A universal power supply with European plug and
12-pin connector
If you are providing power through the 12-pin connector, the PD-12UUP and PD-12UEP power
supplies are available with the 12-pin mating connector already attached to the leads from the power
supply. The PD-12UU or PD-12UE power supply can be connected to the JAI PULNiX power cable
either directly or via a terminal strip.
26 Position
High Density
Mini D Ribbon
(MDR) Male Plug
Cable
26 Position
High Density
Mini D Ribbon
(MDR) Male Plug
2X
Thumbscrews
2X
Thumbscrews
1
23
14
15 16
11
12 13
24
25 26
4
56
17
18 19
7
89
20 21
22
10
23
1
23
14
15 16
11
12 13
24
25 26
4
56
17
18 19
7
89
20 21
22
10
23