Filter
Top Products
Hermes Operator Note Page 11 of 32
4.1.2 Ending of Command Mode
The command mode is ended by inputting the string:
ATO<CR><LF>
The modem responds with:
OK<CR><LF>
The modem is now ready for normal modem operation.
Note that the communication parameters (baudrate etc) are the programmed
parameters.
4.2 Command Syntax
4.2.1 Note: Capital letters MUST be used for all command instructions.
4.2.2 All syntax commands with multiple ‘n’ ‘s accept multiple formats. For
example, if ‘nnn’ is specified in the command string, then the following will
be valid:
1 or +1
01 or +01
001 or +001
4.2.3 The commands for reading registers have the form:
AT S158?<CR><LF>
The answer to this query is:
nnn<CR><LF>
4.2.4 After setting a parameter the modem responds with:
OK<CR><LF> if a valid entry and
ERROR<CR><LF> if an invalid entry