Filter
Top Products
13
ENGLISHDEUTSHFRANÇAISITALIANOESPAÑOL
DLA-M5000CLE (Re)/ LCT0979-002A / ENGLISH
Installing the Projector
Precautions for Installation
■
When installing the projector, observe the followings:
• Do not use the projector placed on its side or upside down.
The projector can not be used by being placed on its side or upside down; Otherwise, it could malfunction.
• Use the projector within the installed angle.
Avoid using the projector inclined ±5° or more right-to-left or left-to-right. This could cause color variation or harm the
lamp life.
• Do not block the exhaust vents.
Do not use a cover which encloses the projector air-tight or blocks the exhaust vents. Allow sufficient space around the
projector. When the projector is enclosed in a space of the following dimensions, use an air conditioner so the
temperature inside becomes equal to the outside temperature.
Allowable minimum space required
CAUTION
• Since the projector weighs approx. 70 kg (154 lbs.), be sure to use four or more people when lifting or moving it;
otherwise, the projector could possibly drop, causing personal injury and/or damage to the projector.
• Do not install the projector in the following places:
• There is much water, humidity or dust.
• The projector may be subjected to oil smoke or cigarette smoke.
• On a soft surface such as a carpet or cushion.
• The projector may be subjected to direct sunlight.
• Temperature is high or humidity is low.
Allowable operation temperature range: + 5°C to + 40°C
Allowable relative humidity range: 90% or less (no condensation)
Allowable storage temperature range: –5°C to +60°C
R
RGB
Y/C VIDEO
G H/CS
BV PR/R-Y
P
B/B-Y
Y
RGB OUT
RS-232C
REMOTE
RGB IN-2
CONTROL
EXT. IN
RGB IN-1
305 mm
600 mm
305 mm
600 mm)
600 mm
DLA-M5000LE&SCE Eng Re.book Page 13 Tuesday, March 12, 2002 3:59 PM