Filter
Top Products
4
Installation
CAUTION
• Do not rest your arm on the monitor or lean against the monitor.
• Do not hold the LCD panel when installing the monitor.
• Make sure to install the monitor securely to prevent the monitor from falling over, which causes damage to the monitor or injury.
7 Using the monitor on the stand
You can place the monitor in the following two ways when using the monitor on the supplied stand.
You can tilt the monitor from about 6° upward to
about 6° downward.
• When the monitor is not tilted (0°), the guidelines
align as illustrated below.
When the stand plate is attached to the higher
position of the stand body (☞
“To adjust the stand
height” on page 5), you can lift the stand up by about
148° and place the monitor as illustrated below.
• Remove the screws on the left and right sides of
the stand (see the illustration below), then lift the
stand up by about 148°.
Make sure of attaching the removed screws after
lifting up the stand.
• To place the monitor as illustrated on the left again,
remove the screws on the left and right sides of the
stand, return the monitor angle to 0°, then attach
the removed screws.
To detach the stand
CAUTION
• Lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel being damaged.
The illustration of the monitor is of DT-V24L1D.
CAUTION
• Be careful not to pinch your fingers in the gap between the
monitor and the stand.
• When the stand plate is attached to the lower position of
the stand body (☞ “To adjust the stand height” on page 5),
you cannot tilt the monitor downward.
About 6°
About 6°
The illustrations of the monitor are of DT-V24L1D.
CAUTION
• When lifting up the stand, lay the monitor on a cloth with
the LCD panel facing down to prevent the LCD panel being
damaged.
• Be careful not to pinch your fingers in the moving parts.
• Make sure to lift the stand up until it stops (about 148°);
otherwise the monitor may fall over.
• Place the monitor on a mat to avoid scratching the table
surface.
• Do not place the monitor in this way when the stand plate
is attached to the lower position of the stand body (☞ “To
adjust the stand height” on page 5).
Screw holes for
stand attachment
Screw holes for
stand attachment
(on the monitor)
Screw holes for
stand attachment
(on the stand)
Stand
Guides
Guide holes
Attachment screws
Stand
Monitor
Monitor
When installing the stand to the monitor, insert the guides of the stand into the guide holes
on the monitor to place the stand on the correct position. Then fix the stand firmly with the
attachment screws.
The illustration of the monitor is of DT-V24L1D.
About
148°
Screw (silver)
0°
Guidelines
DT-V2420L1D_UA_R.indd 4DT-V2420L1D_UA_R.indd 4 06.11.17 10:40:13 AM06.11.17 10:40:13 AM