JVC DT-R24L4D Computer Monitor User Manual


 
12
The operation procedure
1
Display the menu.
To display the MAIN MENU
Press MENU button.
To display the SET-UP MENU
Press button while holding button.
¨
¨
MAIN MENU SET-UP MENU
Selected
item
Operation
guide
2
Press buttons to select an item, then press button.
For some items, adjustments will be made by pressing .
Ex.: When “MARKER” in the MAIN
MENU is selected
3
Press buttons to select an item, then press buttons to make adjustments.
4
Press MENU button to nish the menu operation.
Pressing MENU button repeatedly deactivates the display of the menu.
Menu Transition Diagram
MAIN MENU
PICTURE FUNCTION
APERTURE AREA MARKER
APERTURE LEVEL MARKER ASPECT
BACK LIGHT
CTI SAFETY MARKER
LTI SAFETY AREA
I/P MODE FRAME
sub menu CENTER MARKER
reset LINE BRIGHTNESS
R-AREA MARKER
R-MARKER ASPECT
R-SAFETY MARKER
BALANCE
R-SAFETY AREA
NO SYNC ACTION
DELAY TIME
LOW LATENCY
AUTO ASPECT
AUDIO1 ASSIGN.
*1
LEVEL METER SETTING LEVEL METER CH
BAR TYPE
REFERENCE LEVEL
OVER LEVEL
BAR BRIGHTNESS
PEAK HOLD
E.AUDIO GROUP
AUDIO2 ASSIGN.
*1
MARKER
AUDIO SETTING
SYNC FUNCTION
MANUAL ASPECT
SD4:3 SIZE
FUNCTION SETTING
sub menu POSI.
COLOR SYSTEM
PICTURE SUB ADJ.
CONTRAST TALLY SELECT
BRIGHT DIMMER
SIZE/POSI. ADJ.
H SIZE CHROMA COMPONENT PHASE
H POSITION PHASE
WHITE BALANCE SET.
V SIZE NTSC SETUP
V POSITION sub menu
REMOTE SETTING
sub menu reset
reset
INFORMATION
COLOR TEMP.
SERIAL TYPE R DRIVE
CONTROL LOCK
POSITION PARALLEL TYPE G DRIVE
SOURCE ID PIN1 B DRIVE
DVI INPUT SEL.
CHARACTER SET. PIN2 R CUT OFF
STATUS DISPLAY PIN3 G CUT OFF
all reset
TIME CODE PIN4 B CUT OFF
CRC ERROR PIN5 sub menu
SUB HOUR METER PIN6 reset
MODEL PIN7
VERSION PIN8
HOUR METER
SET-UP MENU
COLOR GAMUT
*1
*1
DT-R24L4D only
The menu automatically disappears in about 30 seconds after the previous operation.
Some items may not appear on the menu depending on the input or the input signal.
The items controlled by the MAKE system do not appear on the menu.
Menu Con guration