Filter
Top Products
16
• For easy understanding, pictures and illustrations are shown by being emphasized, omitted or
composed, and may be slightly different from actual products.
• Design and specifications are subject to change without notice.
• All company names and product names mentioned herein are used for identification purposes
only, and may be the trademarks or registered trademarks of their respective companies.
Notice on transportation
This monitor is precision equipment and needs dedicated packing material for transportation.
Never use any packing material supplied from sources other than JVC or JVC-authorized dealers.
7 Input/output terminals
Video
VIDEO 1 IN/OUT
VIDEO 2 IN/OUT
Input/output of composite signal:
1 line, BNC connector x 2, 1 V(p-p), 75 Ω
* The input (IN) and output (OUT) terminals are bridge-connected (auto
termination).
VIDEO 1 Y/C Input of Y/C signal:
Y/C connector x 1
Y: 1 V(p-p), 75 Ω
C: 0.286 V(p-p), 75 Ω (for NTSC)
0.3 V(p-p), 75 Ω (for PAL)
DVI-D DVI-D signal input:
DVI-D connector x 1 (compatible with DDC2B)
RGB Input of analog RGB signal: D-sub 15-pin x 1
G: 1 V(p-p), 75 Ω
G. on sync: 0.3 V(p-p)
B, R: 0.7 V(p-p), 75 Ω
H. sync: TTL
V. sync: TTL
C. sync: TTL
TTL: LOW: 0 V – 0.8 V
HIGH: 2.5 V – 5 V
Audio
AUDIO INPUT (VIDEO 1,
VIDEO 2)
Analog audio signal input: 1 line, RCA connector,
500 mV (rms), high impedance
AUDIO INPUT (RGB, DVI-D) Analog audio signal input: 1 line, stereo mini jack,
500 mV (rms), high impedance
External control
REMOTE (MAKE/TRIGGER)
☞ “External Control” on page 13
VESA mounting holes
(4-M4, depth: 10 mm)
1
404.8 mm (16˝) (at the higher position)
369.5 mm (14 5/8˝) (at the lower position)
7
74 mm (3˝)
=
100 mm (4˝)
8
29 mm (1 1/4˝)
~
100 mm (4˝)
2
364 mm (14 3/8˝)
9
1.5 mm (1/16˝)
!
187 mm (7 3/8˝)
3
413 mm (16 3/8˝)
0
46 mm (1 7/8˝)
4
199 mm (7 7/8˝)
-
199 mm (7 7/8˝)
5
104 mm (4 1/8˝)
6
240 mm (9 1/2˝)
3
4
5
0
6
7
-
=
~
1
2
8
9
!
<Stand bottom>
Specifications (cont.)
7 Dimensions
<Front view> <Side view> <Rear view (without the stand)>
LMH191EA_EN.indd 16LMH191EA_EN.indd 16 08.4.18 0:45:57 PM08.4.18 0:45:57 PM