Kenmore 600E Printer User Manual


 
Getting Started 2-9
NovaJet PRO 600e User's Guide
GETTING STARTED
2 Press the button on the NovaPrime to activate the vacuum and draw ink from the
reservoir into the needle.
3 When ink is visible in the NovaPrime sight tube, remove
the cartridge needle from the NovaPrime and quickly
insert it into the hole in the top of the ink cartridge. Be
sure the needle is tightly connected by turning the fitting
clockwise until finger-tight.
4 Gently tighten the fitting (about 1/4 turn) to prevent air
leaks. Do not overtighten. Wait 20 seconds for the
pressure to stabilize.
5 Remove the cartridge from the carriage and remove the
blue tape from the jet area of the cartridge. CAUTION! Do not tilt the cartridge up
higher than a 30 degree angle. This could cause the cartridge to lose
pressure.
6 Rotate the cartridge one complete revolution counterclockwise to ensure that there
are no twists in the ink delivery line.
Check for ink on the jet plate. Continuous bleeding of the jet plate indicates a loss
of vacuum in the cartridge or an air leak in the lines. A small amount of ink can be
cleaned off the jet plate by dabbing with a moist, lint-free cloth.
7 Insert the cartridge into the carriage.
8 Repeat with each cartridge.
9 Press Utility/Access Cartridges to return the car-
riage to the service station.
10 Print the color test, prime test pattern and paper
axis test as described in the following sections.
11 If all colors look fine, go on to step 15. If any color
drops out, prime cartridges as necessary, using the
NovaPrime.