Filter
Top Products
E-11
A Check of the Supplied Items and the Names of the Parts
Names and Functions of the Parts (Operation Panel)
1. ON/STANDBY LED
Lit red during standby and lit green when the projection
lamp is on. See Page E-21.
2. LAMP/COVER LED
Lit green during projection. Lit red when the air filter or
lamp unit cover is not in place.
• At the time of the projection lamp lighting operation, the
LED ashes for about 6 seconds and then lights green.
• At the time of a projection lamp lighting failure, the LED
ashes green. (The ashing interval when the projection
lamp is off will be longer than when the LED ashes at
other times.)
• When the projection lamp is off, the LED ashes green
for 60 seconds and then goes off.
• When the projection lamp has been used in excess of
1,900 hours, the LED ashes red; when use exceeds
2,000 hours the LED is lit a steady red.
See Page E-41.
3. TEMP LED
When the internal temperature has risen excessively, the
LED ashes red for 10 seconds, then is lit a steady red.
See Page E-41.
LED List
LED State
Significance
ON/
STANDBY
LAMP/
COVER
TEMP
Off Off Off AC power OFF
Normal
condition
Red Off Off Standby
Green
Flashing
green
Off
Standby to start of projec-
tion
End of projection to
standby
Green Green Off Projecting
Red Red Off
Lamp cover open
Power
has been
switched
OFF
because of
the alarm
Lamp burned out
Lamp usage exceeds
2,000 hours
Red Orange Off Internal problem
Red Off Red
Temperature fault
Fan fault
Green
Flashing
red
Off
Lamp usage exceeds
1,900 hours
Alarm
sounding
Green Green
Flashing
red
Abnormal temperature
warning
4. POWER Button
Switches the power of the projector on or off (standby
mode).
• Only this button is effective when the projection lamp is off.
See Page E-21.
5. INPUT button
Press this to switch the input.
The input switches as follows: OHP → PC → VIDEO or
OHP → VIDEO (D4) → VIDEO.
See page E-23.
6. PORTRAIT/TRANSFER button
When OHP is selected: Switches the orientation of the pro-
jected image. When switched, the image is adjusted to the
width.
See page E-23.
When a USB cable is connected, the images stored in the
internal memory are transferred to the computer. (This
function is only available on the iP-30SE.)
See pages E-26 and 28.
7. FREEZE OFF Button
Cancels the still image mode.
This is used when checking the projection screen while
moving the document.
See Page E-27.
8. FREEZE/CAPTURE Button
Makes the projection screen image into a still image. In the
OHP mode, the image is stored in internal memory as a
thumbnail.
See Page E-26.
ON/STANDBY
LAMP/COVER
TEMP
FREEZE OFF
FREEZE/CAPTURE
PORTRAIT
INPUT
POWER
TRANSFER
1 2 3 4 5 6 7 8