Filter
Top Products
E-21
Connection of the Power Cable and On/Off Switching
Switch On the Power
1
Connect the power cable
The projector will enter the standby mode and the ON/STANDBY LED will light in red.
2
Press the POWER button ( )
Switch Off the Power
1
Press and hold the POWER button ( ) for 1 second or longer
"Press POWER button again to turn off" will appear on the projection screen.
2
Press the POWER button ( ) one more time.
The lamp will go off.
• The lamp/cover LED ashes green, then turns off once cooling is completed.
The ON/STANDBY LED lights in resistance.
• When the lamp is off, pressing the POWER button while the LAMP/COVER LED is ashing green will not switch the
lamp on again.
To switch the lamp on again, please press the POWER button again after the ON/STANDBY LED lights in red.
3
Disconnecting the Power Cable
The ON/STANDBY LED on the operation panel will go off.
The power cord can be disconnected even while the lamp/cover LED is ashing green (direct power off function). The fan
continues to run for a while to cool the machine.
The projector is now able to make a projection.
3
Switch on the power of the connected equipment
CAUTION
T
E
S
T
R
G
B
S
V
L
R
A
U
D
I
O
U
S
B
O
N
/
S
T
A
N
D
B
Y
L
AM
P
/
CO
V
ER
TE
M
P
F
R
E
E
Z
E
O
F
F
F
R
E
E
Z
E
/
C
A
P
T
U
RE
PO
R
T
RA
I
T
IN
P
U
T
PO
W
ER
T
RANS
FE
R
ON/STANDBY
LAMP/COVER
TEMP
INPUT
POWER
ON/STANDBY
LAMP/COVER
TEMP
POWER
To wall outlet.
Operation with the
Projector
Operation with the
Remote Control
The fan will turn, the lamp will light, and the ON/STANDBY LED will light in
green. The LAMP/COVER LED will light in green.
• If the LED lights in red after the POWER button is pressed, projector
trouble is indicated.
→
See Page E-41
• Check that the lens cap has been removed before pressing the POWER
button.
Operation with the
Projector
Operation with the
Remote Control
ON/STANDBY
LAMP/COVER
TEMP
POWER
• Do not disconnect the power cord while the lamp is lit.
• Unplug the power plug of the projector from the wall outlet when the projector will not be used for an
extended period.
• When the reinserting the power plug into the outlet soon after having unplugged it, please allow a
xed time (of about 10 seconds) before doing so.
• Wait for the cooling fan to stop turning before stowing away.