Filter
Top Products
14
AUTO POWER OFF (APO)
Auto Power Off is useful when you unintentionally leave the
transceiver power ON. This function saves battery consump-
tion. After two hours elapse with no controls adjusted or
activated and no calls received, APO turns the transceiver
power OFF. One minute before power is turned OFF, a
warning tone sounds (even if the beep tone has been turned
OFF).
1 Enter the Menu Settings (page 12) and
press the ▲ or ▼ key until you reach the
“APO” display.
2 Press the
key to turn the Auto Power
Off function ON (
) or OFF ( ).
3 Press the PTT switch or turn the
transceiver power OFF to confirm your
setting.
• If you have turned the APO function ON,
the APO icon appears on the display.
AUTO CHANNEL SELECT
Auto Channel Select allows you to scan the transceiver
channels to search for a signal. When the transceiver verifies
a signal on a channel, it proceeds to check whether or not its
Group Mode number matches that which is set up on your
transceiver. (Auto Channel Select will not operate if no Group
Mode number is selected.) If the Group Mode number
matches, the transceiver stops at the channel and opens the
squelch so you can listen to the call. If the Group Mode
number does not match, the call is ignored and scanning
continues.