Filter
Top Products
KD-MSW4x2 Operating Instructions
Page 22
KD-MSW4x2 Operating Instructions
Page 23
Applying Power
Now that the A/V input and output interfaces are completed, it is recommended to double check all
cables and connections before applying power.
To test connections before routing or hiding any wires behind walls or ceilings, use a reliable source
(like a DVD player) and display that is known to be functioning properly.
Once all the connections have been verified, plug the connector of the Power Supply into the
power supply input jack on the rear panel of the KD-MSW4x2 unit.
Next, plug the external Power Supply provided with the unit into an appropriate wall outlet or source
of AC power. The external power supply is rated: + 6V DC @ 5 Amps, 110-240 VAC, 50-60 Hz. For
added safety and protection it is recommended to use a good quality surge protector.
The KD-MSW4x2 unit has no physical On/Off switch, except on
the provided IR remote control.
IR Extender
A rear-panel IR sensor is provided, ideal to use with an IR Extender,
like one provided by Xantech. The rear panel IR sensor also supports
the IR remote control provided with the KD-MSW4x2 unit.
Wired IR
A rear-panel wired IR serial connector is provided for use with an IR Extender, like one provided by
Xantech. Connect the wired IR Extender to the 3.5 mm jack on the rear panel of the KD-MSW4x2
unit.
Mount the IR extender on the rear panel of the KD-MSW4x2 unit, or connect the wired serial connector cable to the
wired IR connector jack on the rear panel.
CAUTION: No other power supply adapter can be used
with the KD-MSW4x2 unit. Use only the Power Supply
provided in the carton! Using a power supply other than
the one provided by Key Digital“ with the unit VOIDS THE
WARRANTY, may cause damage to the unit and associated
equipment, and is a potential safety hazard.
Always test all connections and final operation first, before sealing cables behind
walls or completing difficult wire routings.
Carefully insert the Power Supply adapter plug here