Filter
Top Products
KNS3250/R Users Guide - Rev. A00 Kingston Technology Company
Hardware Installation 7
Full Duplex and Collision LED
The FDX/COLL LED uses a single color LED to display two functions. A solid
green light indicates that Full-Duplex operation has been detected. A ashing
amber light indicates that a collision has occurred in half-duplex mode. Full-
Duplex mode is auto-negotiated on all UTP ports.
Fiber FX module port (optional)
The ber FX module port can be used with an optional MT-RJ, ST, or SC ber
module. Port 1 & 2 on the switch are associated with this module. If the optional
module is used, then port 1 & 2 on the switch can not be used. For more details on
the modules and instructions on installing them, please refer to Appendix D - Fiber
FX Modules and installation.
10/100TX UTP Ports
The Fast EtheRx Switch has 16, 24, or 32 (depending on model) UTP ports that
auto-negotiate both 100BASE-TX and 10BASE-T connections, as well as half- or
full-duplex operation.
Rear Panel
100-240VAC
50-60Hz
.07A MAX
CONFIGURATION PORT
Configuration Port
AC Power Connector
Fig.3 - Rear Panel
AC Power Connector
The Fast EtheRx Switch uses a 100-240VAC internal power supply. Connect the
AC power cord from the back of the unit to an AC electrical outlet.
Conguration Port
The Fast EtheRx Switch can be managed using the Kingston Switch Conguration
Utility by connecting the conguration cable from the Conguration Port to the
parallel port on the back of your host computer.