Filter
Top Products
NovaJet 500/630/700 Series Service Manual
ASSEMBLY/
DISASSEMBLY
Assembly\Disassembly 5-7
Applying too much torque to the lower screws can cause
the mounts for the standoffs on the cover to break, re-
quiring a replacement of the cover.
8. Using a #2 Phillips screwdriver, secure the Right Cover with two
screws located on the left side (torque to 15 in-lbs) and three
located under the baseplate (torque to 8 in-lbs.)
To install the Top Cover:
9. Insert the pin located on the right side of the Top Cover into the
corresponding hole on the Right Cover Assembly.
10. While depressing the retracting stop assembly on the left side of
the Top Cover, lower the left side of the Top Cover into position
and secure it to the Left Cover Assembly by releasing the
retracting stop assembly.
Remove the Keypad and Display
1. Perform steps 1 through 9 of the Remove the Left, Top, and Right
Covers procedure to remove the Top and Right Covers.
2. Turn the Right Cover Assembly over and with a 1/4” socket or
wrench, remove the four kepnuts securing the ESD Shield and
ground connections. See Figure 5-4. Remove the ESD Shield.
3. With a 1/4” socket or wrench, remove the four standoffs and
washers that secure the LCD Display Assembly to the Keypad.
Remove the Display Assembly.