Filter
Top Products
NovaJet 500/630/700 Series Service Manual
ASSEMBLY/
DISASSEMBLY
Assembly\Disassembly 5-49
6. Reaching inside the Fan Exhaust hole under the Platen, position
and secure the Fan Assembly(ies) using a #2 Phillips screwdriver.
7. Reinstall the Fan Exhaust Assembly(ies) using a #2 Phillips
screwdriver.
8. Install the Lower Drive Roller Assembly support brackets using a
#2 Phillips screwdriver.
9. Install the Center Support Bracket. Insert the Platen Plug.
10. Reinsert the right Foam Block. Make sure that the Stepper Motor
and Fan(s) cables are exiting out of the back corner of the Foam
Block. See Figure 5-27. The Foam Block is positioned between the
Stepper Motor and the Servo Motor. Make sure it is not tilted at
an angle.
SERVICE
STATION
STEPPER
MOTOR
P/O LEG HARNESS
FOAM
BLOCK
Figure 5-27. Inside Platen, Right Side.