Filter
Top Products
7
COMMANDS AND EFFECTS
Overview
The following table gives and
overview of all commands and effects.
All commands with * can also be used
for projection with a single
EKTAPRO 7010, 7020, 9010 or 9020
Projector!
Tip
• The last code input via the numerical
keypad of the IR remote control
remains stored. If the command has
to be reinput, it is only necessary to
press the <*> key.
• If you input an incorrect figure on
the numerical keypad of the IR
remote control, press clear <C>
before reinputting your figure.
Function Code
* Setting dissolve times
(Soft Slide Change in
single projection)
801 - 899
* Random Access 0 - 160
Fade (MASTER) 770
Fade (SLAVE) 707
Alternate (Crossfading
without slide change)
777
* Freeze 789
Independent Projector
Control Mode
980
Parallel Projection Mode
Activate Focus for SLAVE˚
970
666˚
Reactivating of the dissolve
mode
990
* Remote Security Mode 989
* Rest 999
* Auto-Timer 600 - 660
˚
Function is inactivated for
models 7010 and 9010!
DISSOLVE
Basic setting
After switching on you can
immediately begin a dissolve
presentation. Dissolving takes place
with a default time of 0.5 seconds.
As soon as you press the transport
forwards button of the remote control
both slide trays go to position 1 and the
MASTER projector fades the no. 1
slide up at the specified time. If you
push the button again the first dissolve
happens: slide no. 1 is faded down in
the specified time and at the same time
slide 2 is automatically faded up. Then
the slide tray of the MASTER projector
is automatically transported one
position further and the projector is
ready for the next dissolve. The
dissolve process also functions in the
same way when you push the transport
backwards button.
Notes:
You can interrupt a presentation if the
dissolve time is greater than one
second. If a dissolve has already
started, it can be interrupted by
pressing the forward button again at
lest 1 sec into the dissolve. The
presentation will move on to the next
slide. Continuously pressing the
forward button will interrupt each
dissolve after one second and move on
to the next.
Dissolve times with IR remote
control
You can input
dissolve times of
0 seconds(so-called
hard cut) up to a
long dissolve of
9.9 seconds in
increments of a
tenth of a second.
The numerical combinations of
800 ...899 on your remote control are
reserved for this. Pleaseensure that you
press the ENTER button <*> after
inputting the relevant combination.
Only then is the command received by
the projector and the time stored. As
soon as you press the transport button
on your remote control, the first
dissolve takes place.
Examples:
If you want a dissolve time of
1 s :➔ Input <810> and confirm with <*>.
5.5 s :➔ Input <855> and confirm with <*>.
0 s (Hard Cut) :➔ Input <800> and confirm
with <*>.
Important
The dissolve time you have input is
retained until you overwrite it with a
new time (via the IR remote control).
After a reset (switching off and back on
again) the time you have input with the
IR remote control is deleted (see Basic
setting).
SELECTING SLIDES
As in the case of individual projection,
you can transport backwards and
forwards at will, or select slides
directly (random access). The slide
sequence is always retained and the
projector which is currently “dark” is
automatically carried to the next slide
in your presentation.