Filter
Top Products
Using the Projector
39
Projection, then click the left or right navigation button to turn this
feature on and off.
Default Source
Default Source toggles among Computer analog, Computer digital,
and Video. This determines which source the projector checks first
for active video during power-up. Highlight Default Source and click
the left or right navigation button to toggle among the options.
Auto Source Select
This setting toggles between On and Off. When this feature is Off, the
projector defaults to the source selected in Default Source. To display
another source, you must manually select one by pressing the
source
button on the keypad or the
computer or video button on the remote.
When this feature is On, the projector automatically finds the active
source, checking the default source first. Highlight Auto Source
Select and click the left or right navigation button to turn this feature
on and off.
Plug and Play
This setting toggles between On and Off. When it is On, most new
computers will automatically recognize the projector, then set the
monitor resolution and refresh rate accordingly. You need to set the
Plug and Play setting to Off for the projector to display properly on
some older computers. The Plug and Play setting does not affect
video images.
If the projector’s display constantly changes between the computer
image and the message, “Perfecting the image”, you may need to turn
Plug and Play Off.
Display Messages
This setting toggles between On and Off. When this feature is On,
status messages such as “No signal detected” or “Standby Active”
appear in the lower-right corner of the screen. Click the left or right
navigation button to turn this feature off and not see status messages.