Kodak DP2900 Projector User Manual


 
User Guide KODAK DP2900 Digital Projector
46
Replacing the Projection Lamp
Warning: To avoid burns, allow the projector to cool for at least 30
minutes before you open the lamp module door. Never
extract the lamp module while the lamp is operating.
,PSRUWDQW 7KHODPSLQWKH.2'$.'3FRQWDLQVWUDFHDP RXQWVRIPHUFXU\
6RPHJRYHUQPHQWVUHTXLUHVSHFLDOGLVSRVDORIODPSVFRQWDLQLQJPHU FXU\
'LVSRVHRIODPSVLQDFFRUGDQFHZLWKWKHODZDQGDQ\DSSOLFDEOHORFDO
UHJXODWLRQV
The lamp hour counter in the Status menu counts the number of hours
the lamp has been in use. Replace the lamp when the brightness is no
longer acceptable. To order replacement lamp modules contact your
dealer of KODAK products or visit our Web site at www.kodak.com/
go/projectors.
Follow these steps to replace the projection lamp:
1. Turn off the projector by unplugging the power cord.
2. Wait 30 minutes to allow the projector to cool thoroughly.
3. Invert the projector on a soft flat surface, then insert a small
screwdriver or other flat object into the tab on the lamp module
door.
.