Filter
Top Products
KODAK V600 Digital Projector and KODAK V600 Zoom Digital Projector
32
Safety
These safety precautions include information to prevent personal
injury and damage to the projector.
Safety Definitions
Warning: Statements identify conditions or practices that could
result in personal injury.
Caution:
Statements identify conditions or practices that could result
in damage to your equipment.
Warning: For information about use of a feature, please refer
to this User Guide.
Warning: Hot surface. Do not touch.
Projector Safety
Warning: To replace the lamp, turn off the power and unplug
the power cord. To avoid burns, wait 30 minutes before opening
the lamp door. Follow all instructions provided in this User
Guide. See “Changing the Lamp Module” on page 20.
Warning: When you open the lamp module door, be careful not
to touch the hot surfaces inside.
Warning: Please use the power cord provided. Connect the power
cord to a receptacle with a protective safety (earth) ground terminal.
Warning: Don’t look directly into the lens when the lamp is on.
Doing so may cause eye injury.
Warning:
Servicing your own projector may expose you to hazards
or create potential hazards. Also, servicing your own projector will
void the warranty. Refer all service to qualified service personnel. See
“If You Need Assistance” on page 5.
Warning: In the unlikely event of the bulb rupturing, thoroughly
clean the area behind the projector and discard any food that might
have been contaminated with broken glass.
Warning: Do not loosen or remove any screws other than those on
the lamp module door and the lamp module. Doing so may result in
electric shock.
Caution: Don’t set liquids on the projector. Spilled liquids may
damage your projector.
Caution:
Don’t put the projector on a hot surface or in direct sunlight.
Caution: Do not drop the projector.