Filter
Top Products
13
Changing of Lens (RANGE7 only)
Set the RANGE7 at a position proper to the measuring target, and exchange the lens for an optimum one, depending on the measuring
target size and the distance between the RANGE7 and the measuring target.
NOTE
When changing the lens, conrm that the lens number is the same number as the RANGE7 body.
Memo
RANGE7 needs to warm up for about 20 minutes after being switched ON. It is always possible to change lenses, but if the lens
temperature is different from the main body temperature, it may result in inaccurate measurements.
To avoid this problem, change lenses before switching the RANGE7 ON, and warm-up the RANGE7 with the lens to be used
attached. If the lens must be changed after the RANGE7 has already warmed up, wait at least 5 minutes for the lens temperature
to adjust to the temperature of the RANGE7.
[Lens exchanging procedure]
1) Turn the lens mounted to the RANGE7 counterclockwise by holding the
lens barrel. After turning the lens to the hit position, pull it out straight
slowly.
2) Align the side pin of the lens with the red mark on the RANGE7, and
insert the lens straightly according to the inside guide.
3) After inserting the lens to the hit position, turn it clockwise by holding
the lens barrel to tighten it securely.
NOTE
• Remove the lens by reversing the attaching procedure.
• Be careful to avoid touching the lens surface when changing lenses.
Memo
• Grease for lubrication has been applied to the screw for installation
of the lens. When the RANGE7 is purchased, the screw of the
lens not attached to the RANGE7 is wrapped with a transparent
sheet for grease protection. Remove this sheet before use.
• When removing the lens, attach the mount and lens caps.
"
mark"
Mount cap
Lenscap