Filter
Top Products
DS Vision® Digital - Connecting the DS Vision® Digital 7
4 Connecting the DS Vision® Digital
Always switch off the power to each device before connecting it to your
DS Vision® Digital. After connecting your DS Vision® Digital,
connect its power and then switch on the power to each device.
4.1 Connecting the Player and the Screen
To connect the player to a screen, as Figure 4 illustrates, do the following:
1. Connect the player to the broadcaster/transmitter HDMI port using an HDMI
to HDMI cable (type A, male/male) or connect a DP cable to the DP port
(DisplayPort male, male).
2. Connect the screen to the receiver HDMI port using an HDMI to HDMI cable
(type A, male/male).
3. Connect the system cable up to 100m (330ft) to the SYSTEM port of the
broadcaster/transmitter and the SYSTEM port of the receiver.
Important: Make sure to connect the transmitter to the LAN even if
management features are not being used. Connecting the
transmitter/broadcaster to the LAN can enable management of the
system in the future.
4. With the power supplies provided, connect the DC power adapters to the
broadcaster/transmitter and receiver. Plug the power supplies into the mains
electricity.
Once connected, the system is ready to transmit the video and audio signals.
i
i