Filter
Top Products
5
English
Names of parts
Before installing the duplexer, please read the following list of names. These
names are used in describing procedures for installing and using the duplexer.
See Figure 1 on page iii.
Connector: When you install the duplexer, this connector plugs into a connector
located inside the bottom of the printer (or of the optional paper feeder, if used
together with the duplexer).
Positioning pins: These pins fit into two holes in the bottom of the printer (or
of the optional paper feeder, if used together with the duplexer).
READY indicator: Lights when the duplexer is ready. Flashes when a jam
occurs in the duplexer.
Duplexer drawer: Open to install the paper path adaptor, or to clear paper jams.
Rear cover: Opens to allow clearing paper jams.