Lantronix 1-T Network Card User Manual


 
Basic Configuration Command Set
4 - 1
4 - Basic Configuration
Certain parameters must be conÞgured before the MSS can function in the
network. EZWebCon is the recommended way to communicate with and
conÞgure the MSS. This chapter shows an additional method of
conÞguration: the command line interface and MSS command set.
NOTE: Instructions for using EZWebCon are included on the
distribution CD-ROM. EZWebCon also has on-line help to
assist you with configuration.
4.1 Command Set
The command line interface allows users to enter commands at the Local>
prompt to conÞgure, monitor, and use the server. This chapter covers many of
the MSS commands. The full command set is discussed in detail in the
Commands chapter of the MSS Reference Manual on the CD-ROM.
NOTE: To return to factory defaults, press and hold the Reset button
while cycling power on the unit, or enter the Initialize Factory
command at the Local> prompt.
4.2 System Passwords
There are two important passwords for the MSS: the privileged password and
the login password. These passwords have default settings and are discussed
in the following sections.
NOTE: Default passwords may pose a security risk and should be
changed as soon as possible. This is especially true of the
privileged password.
4.2.1 Privileged Password
Only the privileged user can change server or port settings. To become the
privileged user, enter the following command. The default privileged
password is system.
Figure 4-1: Set Privileged Command
Local> SET PRIVILEGED