Filter
Top Products
1. Reconnect all the rear I/O assembly cables. See “Locating parts on the system board” on page 71.
2. Position the new rear I/O assembly into the slots, and route the rear I/O assembly cables so that the
excess cables tuck in the rear I/O assembly, and then push the rear I/O assembly 1 downward until the
rear I/O assembly-locking tabs 2 snap into position.
3. Install the two screws 1 that secure the rear I/O assembly to the main bracket.
4. Reinstall the rear I/O shielding. See “Installing the rear I/O shielding” on page 78.
5. Go to “Completing the FRU installation” on page 109.
Replacing the inverter
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important Safety
Information” on page 1.
This section provides instructions on how to replace the inverter.
Chapter 9. Replacing FRUs 97