Filter
Top Products
Note: If a RAID controller or PCI card is installed, you might have to recongure the disk arrays after you
install or remove hard disk drives. See the documentation that comes with the PCI card for more information.
Removing a simple-swap Serial ATA (SATA) hard disk drive
Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all power from the server
before you remove or install a simple-swap hard disk drive.
To remove a simple-swap SATA drive from the bay, complete the following steps.
1. Read the safety information in “Important Safety Information” on page 1 and “Guidelines for trained
service technicians” on page 115.
2. Make sure that the server cover is in place and fully closed.
3. Turn off the server and peripheral devices, and disconnect the power cord and all external cables.
4. Remove the ller panel 2 from the bay.
5. Pull the loops of the drive tray toward each other and pull the tray 3 out of the bay.
000000000
000000000
000000000
000000000
000000000
000000000
00000
00000
00000
000
000
000
Installing a simple-swap Serial ATA (SATA) hard disk drive
Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all power from the server
before you remove or install a simple-swap hard disk drive.
To install a simple-swap SATA hard disk drive, complete the following steps.
Note: If your server has only one simple-swap hard disk drive, make sure it is installed in the left drive bay.
Attention: To avoid damage to the hard disk drive connectors, make sure that the server cover is in place
and fully closed whenever you install or remove a hard disk drive.
1. Read the safety information in “Important Safety Information” on page 1 and “Guidelines for trained
service technicians” on page 115.
2. Make sure that the server cover is in place and fully closed.
3. Turn off the server and peripheral devices, and disconnect the power cord and all external cables.
4. Remove the ller panel 2 from the bay if necessary.
5. Pull the loops of the drive tray toward each other, and slide the drive 3 into the server until the drive
connects to the back plate 1 .
Chapter 6. Replacing FRUs 127