Filter
Top Products
5. Connect the DVD drive cable to the system board connector 1 .
6. Reconnect the DVD drive power cable to the power supply cable.
7. Reinstall the DVD drive (see “Replacing a DVD drive” on page 163).
8. Reinstall the riser-card assembly (see “Installing the riser-card assembly” on page 157).
9. Go to “Completing the FRU replacement” on page 172.
Replacing a DVD drive
To replace a DVD drive, complete the following procedures:
Removing a DVD drive
To remove a DVD drive, complete the following steps:
1. Read the safety information in “Important Safety Information” on page 1 and “Guidelines for trained
service technicians” on page 115.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see “Removing and installing the cover” on page 119).
4. Pull the release tab 1 (the rear of the drive-retention clip) toward the right side of the server to release
the clip; then, while you pull the tab, push the drive out of the bay.
Note: You might have to push the right-rear corner of the drive toward the front of the server to move
the drive initially.
5. Remove the retention clip 1 from the drive and save for future use.
Chapter 6. Replacing FRUs 163