Filter
Top Products
Name
This section displays the video camera's IP address, name, login username, and the destination folder for
the video recording files. Additionally, using the Camera Configuration link, you can modify the video
camera software configuration settings using the video camera's native software. It also displays an icon
that indicates the current state of the video camera. The possible states are:
The video camera is no longer connected to the network.
The video camera is no longer connected to the network, but a recording schedule is set for it. You
should delete this video camera if it is no longer on the network, or fix the network connection so it
can record as scheduled.
The video camera is connected to the network and is currently recording. There is no schedule for
this recording, since it was started manually. The recording must therefore be stopped manually.
The video camera is connected to the network, a recording schedule is set, and the camera is
currently recording.
The video camera is connected to the network and a recording schedule is set for it, but it is not
currently recording.
The video camera is connected to the network, but no recording schedule is set.
Space
The Space column identifies how much disk space is currently used by the video files in the destination
folder for this video camera.
Model
This column lists the model information for this video camera.
Action
For each video camera, you can perform the following actions:
● Click either to manually start recording or to stop recording. These buttons are
available only for video cameras that are currently connected and accessible on the network. Use
the manual start and stop record buttons to start recording at any point and to stop a recording
until the next scheduled start time.
NOTE: During recording, if you want to change the camera resolution and frame rate, you must
stop recording, change the values on the camera's configuration page, and then start the
recording again.
● Click to open a live view from your video camera. You may be prompted to supply the
username and password for the video camera.
Adding a Video Camera
You can use the Video Surveillance page to manually add supported video cameras if they are not
discovered automatically on your px4-300r. The Video Surveillance page also displays the current settings
for any video camera attached to your network. For example, you might have video cameras on a summer
house in one geographic location, while your px4-300r is in another geographic location.
If your video camera is already listed, you can modify its settings. To manually add a video camera,
reference the instructions below.
Media Management
Videos 123