Filter
Top Products
Installing the monitor driver in Windows XP
To use the Plug and Play feature in Windows XP, files should be loaded from the
Reference and Driver CD.
Note
: This section must be completed before continuing with the Windows XP
automatic image setup.
2. Ensure tha� he monitor is connected correctly.
3. Turn on the monitor and then the system unit. Allow the system to boot into
Windows XP.
4. Open the Display Properties window by clicking
Panel, and then double-clicking the Display icon.
5. Click the tab.
6. Click the Advanced
7. Click the Monitor tab.
8. Click the Properties
9. Click the Drivers tab.
10
. Open the Hardware Update Wizard window by clicking on Update Driver,
an
d then click Next.
11. Select Install from a list or Specific location(Advanced), and then click Next.
13. Click OK.
15. Choose L151 Monitor and click OK. The files will be copied
from the CD to your hard disk drive.
16
. Close all open windows and remove the CD.
17
. Restar� he system. The system will automatically selec� he maximum refresh
rate and corresponding Color Matching Profiles.
Note:
On LCD monitors, unlike CRTs, a faster refresh rate does not improve
display quality. Lenovo recommends using either 1024 x 768 at a refresh rate of 60
Hz
, or 640 x 480 at a refresh rate of 60 Hz.
Installing the monitor driver in Windows 2000
To use the Plug and Play feature in Windows 2000, files should be loaded from the
Refe
rence and Driver CD.
Chapter 3. Reference information 3-5