Filter
Top Products
1. Turn off the computer; then disconnect the ac power adapter and all cables from the computer. Wait
three to ve minutes to let the computer cool.
2. Close the computer display, and turn the computer over.
3. Remove the battery. See “Replacing the battery” on page 31.
4. Remove the screws 1 , and then remove the cover 2 .
1
2
2
1
5. If two memory modules are already in the memory slots, press out on the latches on both edges of
the socket at the same time 3 , and then remove a memory module to make room for the new one.
Save the removed memory module for future use.
4
3 3
6. Find the notch on the contact edge side of the memory module you are installing.
Attention: To avoid damaging the memory module, do not touch its contact edge.
7. With the notched end of the memory module toward the contact edge side of the socket, insert the
memory module
5 into the socket at an angle of about 20 degrees; then press it in rmly.
6
5
Chapter 7. Replacing devices 43