Filter
Top Products
Driver installation for DOS environments
31
the most suitable option settings, or you can perform a custom
configuration where you individually select each setting.
Quick installation
This section gives a brief overview of the installation process. For
a more detailed description, refer to The Install Program?
1. Card and Socket Services software should be bundled with your
computer; if it is not, contact your dealer. It is recommended
that you use this software when installing your CardBus
10/100Mbps Ethernet Card.
A system with Card and Socket Services installed allows
the CardBus card to automatically configure itself. While
the system is on, available system resources and insertion or
removal of the card will automatically be detected.
2. Run the INSTALL.EXE program found on your driver disk.
The install program guides you through the installation process
and will install the network drivers needed to run the card on
your network operating system.
If you successfully completed the installation, go to step 5.
If installation was unsuccessful, then go to the next step.
3. If you are using Card and Socket Services, select auto-
configuration. The install program will prompt Card and Socket
Services to assign an available hardware resource configuration.
4. If you do not have Card and Socket Services or if your card
does not work with your version of Card and Socket Services,
the enabler program can communicate directly with the