LevelOne FPS-2013TXU Printer User Manual


 
Unix
Where:
printer_name is the Print Queue name used to store jobs for the corresponding logical
printer
PS_NAME is the LevelOne Printer Server name defined in /etc/hosts
Logical_Printer_name is the logical printer name on the LevelOne Printer Server
(L1..L3 or L1..L8, depending on your model)
Spooler_directory is the directory you created in Step 6.
Example:
Marketing|RP1_PS123456:\
[T
AB] :lp=:\
[T
AB] :rm=PS_Rm203:\
[T
AB] :rp=L1:\
[T
AB] :sd=/usr/spool/Marketing:\
[T
AB] :mx#0:
Repeat this process for each Logical Printer/Print Queue combination that you wish to
create.
LPD on BSD
Before continuing, ensure that an IP Address has been assigned to the LevelOne Printer
Server. Remember the following:
The remote host name is the name of the LevelOne Printer Server.
The remote printer name is the logical printer (L1..L3, or L1..L8) on the LevelOne
Printer Server.
If asked for the LPD type, enter the service type as BSD.
In the sample commands shown, printer_name is the Print Queue serviced by the
logical printer on the LevelOne Printer Server, and Spooler_dir is the name of the
directory used to spool the print jobs.
Procedure
Action Sample Command
Create a spooling directory mkdir /usr/spool/Spooler_dir
Set spooling daemon as owner of
this directory.
chown daemon /usr/spool/Spooler_dir
Create read/write permissions. chmod 775 /usr/spool/Spooler_dir
Give permissions to LPD processes. chgrp daemon /usr/spool/Spooler_dir
Add remote printer(s) See below.
Start lpc print mechanism lpc start printer_name
- 57 -