Filter
Top Products
l
107
802.1w RSTP recommended value: (Valid range: 1 – 200,000,000)
10 Mbps : 2,000,000
100 Mbps : 200,000
1 Gbps : 20,000
Default: 0
Priority:
Priority here means Port Priority. Port Priority and Port Number are mixed
to form the Port ID. Port IDs are often compared in order to determine
which port of a bridge would become the Root Port. The range is 0 – 240.
Default is 128.
Admin Edge Port:
If user selects “Yes”, this port will be an edge port. An Edge Port is a port
connected to a device that knows nothing about STP or RSTP. Usually, the
connected device is an end station. Edge Ports will immediately transit to
forwarding state and skip the listening and learning state because the edge
ports cannot create bridging loops in the network. This will expedite the
convergence. When the link on the edge port toggles, the STP topology
keeps unchanged. Unlike the designate port or root port though, an edge
port will transit to a normal spanning-tree port immediately if it receives a
BPDU.
Default: No
Admin Point To Point:
We say a port is a point-to-point link, from RSTP’s view, if it is in full-duplex
mode but is shared link if it is in half-duplex mode. RSTP fast convergence
can only happen on point-to-point links and on edge ports. This can
expedite the convergence because this will have the port fast transited to
forwarding state.
There are three parameters, Auto, True and False, used to configure the
type of the point-to-point link. If configure this parameter to be Auto, it
means RSTP will use the duplex mode resulted from the auto-negotiation.
In today’s switched networks, most links are running in full-duplex mode.
For sure, the result may be half-duplex, in this case, the port will not fast
transit to Forwarding state. If it is set as True, the port is treated as point-
to-point link by RSTP and unconditionally transited to Forwarding state. If it
is set as False, fast transition to Forwarding state will not happen on this
port.
Default: Auto