Filter
Top Products
32
3-1-2. IP Configuration
IP configuration is one of the most important configurations in the switch.
Without the proper setting, network manager will not be able to manage or view the
device. The switch supports both manual IP address setting and automatic IP
address setting via DHCP server. When IP address is changed, you must reboot the
switch to have the setting taken effect and use the new IP to browse for web
management and CLI management.
Fig. 3-4 IP Address Configuration
Function name:
IP Configuration
Function description:
Set IP address, subnet mask, default gateway and DNS for the switch.
Parameter description:
DHCP Setting:
DHCP is the abbreviation of Dynamic Host Configuration Protocol. Here
DHCP means a switch to turn ON or OFF the function.
The switch supports DHCP client used to get an IP address automatically if
you set this function “Enable”. When enabled, the switch will issue the
request to the DHCP server resided in the network to get an IP address. If
DHCP server is down or does not exist, the switch will issue the request
and show IP address is under requesting, until the DHCP server is up.
Before getting an IP address from DHCP server, the device will not
continue booting procedures. If set this field “Disable”, you’ll have to input
IP address manually. For more details about IP address and DHCP, please
see the Section 2-1-5 “IP Address Assignment” in this manual.
Default: Disable