Filter
Top Products
The following procedure describes the basic steps needed to set up the
IPS-0008:
1. To set up the hardware, connect power to the power inlet and
output devices to the power outlets. Connect digital outputs to the
digital I/O ports, and an EMD to the console port.
2. To configure the IPS-0008, you can use the console or WAN port.
Connect the IPS-0008 to a console and a WAN to enable its
configuration through the console or browser menu.
3. After connecting to a console, use a console application such as
Tel- net or HyperTerminal to access the console menu. Select the
System Group submenu under the IPS-0008 Configuration to set
up the IP address and the system date/time. This IP address will be
used while accessing the web interface to configure the IPS-0008
parameters.
4. After connecting to WAN, open a browser from a PC in the network
and use the IPS-0008 IP address specified through the console
menu to open the web interface for system configuration.
The following sections provide instructions about how to make various
connections.
13