LevelOne IPS-0008 Switch User Manual


 
Error codes
Error code Description
E01 Network link down
E02 Parameters checksum error
E03 Input voltage over threshold high (Volt)
E04 Input voltage over threshold low (Volt)
E05 Outlet A current over threshold (Amp)
E06 Outlet B current over threshold (Amp)
E07 Outlet C current over threshold (Amp)
E08 Outlet D current over threshold (Amp)
E09 Outlet E current over threshold (Amp)
E10 Outlet F current over threshold (Amp)
E11 Outlet G current over threshold (Amp)
E12 Outlet H current over threshold (Amp)
E13 Input source abnormal (for 110V model)
E14 Input source abnormal (for 220V model)
E15 Input current sensor value abnormal
E16 Input source phase incorrect (see note below)
Note: IPS-0008 detects the phase of the input source automatically. If
the phase is opposite to that of the outlet phase, the outlet is turned off.
The corresponding error code is displayed on the input power status
indicator on the front panel with the error code and a message is
displayed in a pop-window from your browser. The log is updated with
information about this event. To prevent this condition from occur- ring,
select the Control Group submenu under the IPS-0008 Configuration
Menu and set the Input Phase Detection item to Disabled.
37