Filter
Top Products
Page 24
2. Use Chooser to select the desired LevelOne Printer Server.
3. Double click the CONFIG file, and edit it. The appropriate values for each line are
described in the following section. The file should look like the example below, but may
vary depending on your model.
Begin CMD
0001 Device Name: xxxxxxxx
3000 Apple Zone : *
3001 Printer Type (P1): LaserWriter
3002 Printer Type (P2) LaserWriter
3003 Printer Type (SP): LaserWriter
3004 Printer Type (P3) LaserWriter
3101 AP_PCOMM1: No
3102 AP_PCOMM2: No
3103 AP_PCOMM3: No
3104 AP_PCOMM4: No
Serial Port Configuration
0030 Baud Rate: 9600
0031 Stop Bits: 1
0032 Parity: None
0033 Data Bits: 8
0034 Handshake: HARDWARE
9002
Do NOT modify the following lines:
beginCMD
9002:
4. Save the file.
5. Double click the icon for PSTool.
6. Click the Printer submenu and choose Download Postscript File. A panel will appear with
a list of files.
7. Click the CONFIG file. Then click Download.
AppleTalk Settings
When editing the CONFIG file, only the parameter should be changed. The parameter is the
last part of the line, after the colon (:). Ensure that you use only valid parameters.
0001 Device Name The Device Name will initially be the Default Server Name. The
Default Server Name is shown on a sticker on the base of the device.
The Device Name can be changed, but the new name MUST NOT
exceed 19 characters in length.
3000 Apple Zone The default value "*" allows all AppleTalk zones to access the
LevelOne Printer Server's printers. To restrict access to a particular
zone, enter the zone name here
Printer Type These are text fields, used to describe the printer driver used for each
port. P1, P2, P3 refer to the parallel ports, while SP refers to the
Serial Port The name can be up to 19 characters long.
AP_PCOMMn
Values for n
These settings determine whether the port uses ASCII or Binary
Communication Protocol. Enter NO for ASCII or YES for Binary.
• Binary communication is twice as fast as ASCII.