Filter
Top Products
Make sure:
• You follow the loading instructions that came with the labels.
• The print side of the labels faces you.
• The adhesive on the labels does not extend to within 1 mm of the edge of the label.
• You use full label sheets. Partial sheets (with areas exposed by missing labels) may cause labels to peel off during
printing, resulting in a paper jam.
• The labels are loaded against the right side of the paper support.
• The paper guide rests against the left edge of the labels.
Transparencies
Load up to 10 transparencies.
Make sure:
• The rough side of the transparencies faces you.
• You don't use transparencies with paper backing sheets.
• The transparencies are loaded against the right side of the paper support.
• The paper guide rests against the left edge of the transparencies.
Note: Transparencies require more drying time. Remove each transparency as it exits, and allow it to dry to avoid ink
smudging.
Custom-size paper
Load up to 100 sheets of custom-size paper (depending on the thickness).
Make sure:
• The total thickness of paper does not exceed 10 mm (0.4 inches).
• The print side of the paper faces you.
• The paper size fits within these dimensions:
Width:
– 76–216 mm
– 3.0–8.5 inches
Length:
– 127–432 mm
– 5.0–17.0 inches
• The paper is loaded against the right side of the paper support.
• The paper guide rests against the left edge of the paper.
15