Lexmark Z42 Printer User Manual


 
Appendix
40
greater of 1) $5,000 or 2) the
amount you paid for the product
that caused the damages. This
limitation of liability will not apply
to claims by you for bodily injury or
damage to real property or
tangible personal property for
which Lexmark is legally liable. In
no event will Lexmark be liable for
any lost profits, lost savings,
incidental damage, or other
economic consequential damages.
This is true even if you advise
Lexmark or a Remarketer of the
possibility of such damages.
Lexmark is not liable for any claim
by you based on a third party
claim.
This limitation of remedies also
applies to any developer of
materials supplied to Lexmark.
Lexmark’s and the developer’s
limitations of remedies are not
cumulative. Such developer is an
intended beneficiary of this
limitation.
Additional Rights
Some states do not allow
limitations on how long an implied
warranty lasts, or do not allow the
exclusion or limitation of incidental
or consequential damages. If such
laws apply, the limitations or
exclusions contained in this
statement may not apply to you.
This warranty gives you specific
legal rights. You may also have
other rights which vary from state
to state.
Electronic emission
notices
Federal Communications
Commission (FCC)
Compliance Information
Statement
The Lexmark Z42 Color Jetprinter
has been tested and found to
comply with the limits for a Class B
digital device, pursuant to Part 15
of the FCC Rules. Operation is
subject to the following two
conditions: (1) this device may not
cause harmful interference, and (2)
this device must accept any
interference received, including
interference that may cause
undesired operation.
The FCC Class B limits are
designed to provide reasonable
protection against harmful
interference in a residential
installation. This equipment
generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can
be determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
Reorient or relocate the
receiving antenna.
Increase the separation
between the equipment and
receiver.
Connect the equipment into an
outlet on a circuit different
from that to which the receiver
is connected.
Consult your point of purchase
or service representative for
additional suggestions.
The manufacturer is not
responsible for any radio or
television interference caused by
using other than recommended
cables or by unauthorized changes
or modifications to this equipment.
Unauthorized changes or
modifications could void the user's
authority to operate this
equipment.
Note:
To assure compliance with
FCC regulations on
electromagnetic interference for a
Class B computing device, use a
properly shielded and grounded
cable such as Lexmark part
number 1329605 for parallel
attach or 43H5856 for USB attach.
Use of a substitute cable not
properly shielded and grounded
may result in a violation of FCC
regulations.
Any questions regarding this
compliance information statement
should be directed to:
Director of Lab Operations
Lexmark International, Inc.
740 West New Circle Road
Lexington, KY 40550
(606) 232-3000
Industry Canada
Compliance Statement
This Class B digital apparatus
meets all requirements of the
Canadian Interference-Causing
Equipment Regulations.