Liebert 208V Power Supply User Manual


 
9
RACK-MOUNT UPS CONVERSION AND INSTALLATION
1. For slide rail installations, first remove the top/side fin. Slide the
top/side fin forward, then lift it up to remove. If desired, install the
optional rack mount handles that were shipped with the UPS.
Securing hardware and slide rails are sold separately. Contact your
local dealer or Liebert representative for these additional options and
any assistance needed.
2. Unpack the two (2) rack-
mounting bracket assemblies
and mounting hardware from
the rack-mounting kit
(P/N: RMKIT18-32). Bracket
assemblies are interchange-
able between left-hand or
right-hand. Remove inner
member of each bracket
assembly as shown at right by
extending it to its outermost
position, depressing the
retaining latch and then pulling
inner member from bracket
assembly.
NOTE
When rack mounted, the UPS must be supported by a shelf,
brackets or slide rails on each side. The rack mount handles
WILL NOT support the weight of the UPS. They are used to
move the UPS into and out of the rack.
+
A
C
I
N
P
U
T
B
A
T
T
E
R
Y
U
P
S
O
N
B
Y
P
A
S
S
U
PStation G
XT
Optional rack mount handles
Return
flanges
Inner
members
Retaining
latches
Front
members
Rear
members