Filter
Top Products
Mounting the Liebert XDV
14
5.2.1 Suspending the Liebert XDV from Unistruts
The Liebert XDV may be bolted to customer-supplied Unistruts. The height of the Unistruts above
the computer cabinet must be adequate to accommodate the combined height of the Liebert XDV and
the baffle.
To suspend the Liebert XDV from a Unistrut system:
1. Bolt the hangers to each corner of the Liebert XDV, inserting the Liebert-supplied bolts into
factory-fabricated holes in the bottom of the Liebert XDV. See Figure 15.
2. Tighten all bolts firmly, taking care not to overtighten the bolts.
3. Using a lifting mechanism, raise the Liebert XDV with brackets attached, to the proper height
and bolt the brackets to the Unistruts.
Figure 15 Suspending Liebert XDV from Unistruts
5.2.2 Suspending the Liebert XDV from Overhead Structures
To suspend the Liebert XDV from the overhead structure using the optional overhead mounting kit
and field-supplied all-thread bolts:
1. Bolt the hangers to each corner of the Liebert XDV, inserting the Liebert-supplied bolts into
factory-fabricated holes in the bottom of the Liebert XDV.
2. Tighten all bolts firmly, taking care not to overtighten the bolts.
3. Install the field-supplied all-thread bolts into the overhead structure, securing them to
components so they will match the layout of the brackets
4. Using a lifting mechanism, raise the Liebert XDV inserting the all-thread bolts through the bolt
holes in the brackets
5. Install field-supplied nuts and washers, on the all-thread bolts, placing them on the bolts at the
level desired for hanging the Liebert XDV.
6. Again using field-supplied nuts and washers, secure the Liebert XDV to the all-thread bolts.
7. Tighten the nuts until the Liebert XDV is level and well-secured.
Unistrut
(field-supplied)
Bolt 3/8" -16; nut and
washer provided in kit
Bolt a bracket to each
corner of the Liebert XDV