Filter
Top Products
Piping
28
6.10 Disconnecting a Liebert XDV With Liebert Flex Pipe From a Liebert XD System
NOTICE
Before uninstalling a Liebert XDV with Liebert Flex Pipe from the prefabricated piping
mains: With the fans running, close the supply service valve, wait approximately
two minutes, then close the return service valve.
Removing a Liebert XDV from above a cabinet will require two people. Read all instructions
before beginning.
Tools Required
• Two adjustable wrenches, maximum adjustment size of 2-1/2 inches
•Two ladders
• Phillips head #2 screwdriver
• Lift mechanism, if the Liebert XDV is suspended above cabinet
1. Ensure the Liebert XDV fan switches are both On and the fans are operational.
2. Close the service valve in the supply line to the Liebert XDV (smaller coupler).
3. With the Liebert XDV fans running, wait two minutes.
4. Close the service valve in the return line to the Liebert XDV (larger coupler).
5. Turn the fan power switches to the Off position. Once the fan switches are turned Off, unplug the
power cords from their power source.
6. Locate and have at the ready the caps and plugs for both ends of the supply and return couplers.
7. Loosen the female supply coupler from the male supply coupler (smaller coupler). This requires
two adjustable wrenches. Refer to Figure 29.
8. The Liebert XDV side of the female coupler must be held stationary while the collar on the
coupler is being loosened. Refer to Figure 29.
9. Disconnect the coupler.
Figure 31 Profile view of the Liebert XD system with one-shot connections
10. Place the protective dust cap and plug back onto both ends of the coupler on the Liebert XDV and
the port pipe.
!
CAUTION
Risk of sudden discharge of pressurized refrigerant. Can cause equipment damage or injury.
Do not disconnect threaded refrigerant couplers at the unit cabinet end without relieving
system pressure. Reclaim any refrigerant during removal of unit from system.
Liquid Sensing
(optional)
Disconnect wiring
prior to moving XDV
Primary and
Secondary
IEC Power
Cord
Rear of the XDV
Serial Tag
Fan Power
Switches
One-Shot Connections
One-Shot Support Bracket
Service
Valve
Return
Line
Supply
Line