Filter
Top Products
1
0
6.2 System Initiating
After you have set up the “HyperTerminal” program, you can power on the switch.
You will see the initializing process appears on the screen.
Here we can see messages shown in this power-on screen. As described in the screen, this is a Self-Diagnostic process
running during power-on stage. Regardless of the test result is successful or not, you are always requested to press <Enter>
to enter next stage.
After you press <Enter> to enter the user interface program, you will see the screen shown as follow:
Log-in is required to access the command console. Apassword is used to provide the basic security control. The factory
default password is “admin”. The user can change password once in the System menu. If the password is forgotten, user must
return this device for SW maintenance. In this log-in screen, input the correct password and press enter will lead user to main
menu. Without valid password, user cannot monitor the system status or set special functions from this interface. We
recommend users take special care of the password.